Detailed Design and Analysis involves decomposing the overall design into smaller, more manageable components, allowing for thorough analysis and evaluation of each component.

Market Analysis is not typically conducted during Detailed Design and Analysis. It is more relevant during the early stages of product development, when gathering customer feedback and understanding market trends is crucial.

FMEA is a systematic approach used to identify potential failure modes, their causes, and their effects on the overall system. It helps engineers take proactive measures to mitigate these risks.

While aesthetics and visual appeal may be important for some products, they are not typically a primary consideration during the detailed design of mechanical components. The focus is on functional performance, reliability, and manufacturability.

Design Verification and Validation (V&V) is crucial to ensure that the detailed design meets all functional requirements and performs as intended. It involves testing and analysis to verify that the design meets the specified criteria.

Life Cycle Assessment (LCA) is not typically used for structural analysis during Detailed Design and Analysis. It is more relevant during the early stages of product development, when evaluating the environmental impact of the product over its entire life cycle.

Thermal Analysis is conducted to evaluate the design's heat transfer characteristics, ensuring that it can operate within the desired temperature range and dissipate heat effectively.

User Acceptance Testing (UAT) is typically conducted during the later stages of product development, when the product is ready for release to the market. It is not typically conducted during Detailed Design and Analysis.

Design Reviews are conducted to ensure that the detailed design meets all functional requirements, adheres to design standards, and is feasible for manufacturing.

Thermal Analysis is typically conducted for mechanical systems to evaluate heat transfer characteristics. It is not commonly used for electrical systems during Detailed Design and Analysis.

Reliability Analysis is conducted to evaluate the design's ability to withstand various operating conditions, ensuring that it meets the required reliability and safety standards.

Stress Testing is typically conducted for hardware systems to evaluate their performance under extreme conditions. It is not commonly used for software systems during Detailed Design and Analysis.

Design Optimization is conducted to improve the design's performance and efficiency, ensuring that it meets the desired specifications and requirements.

Stress Analysis is typically conducted for mechanical systems to evaluate the stresses and strains experienced by components. It is not commonly used for fluid systems during Detailed Design and Analysis.

Manufacturing Analysis is conducted to evaluate the design's manufacturability, ensuring that it can be produced efficiently and cost-effectively using the available manufacturing processes and materials.